2004年10月27日 · Hondabond HT on left, Permatex Ultra Grey on right. The hondabond is much lighter in color, much less goopy, and easier to 'sculpt' into smooth layers, and remove excess without being messy. Hondabond may be made by Permatex (is labeled packaged in USA), but it is not the same as Ultra Grey.

2003年4月27日 · hondabond is a high temp extreme conditions gasket sealent used on honda trannys,oil pumps,water pumps,oil pans. It was developed for use in Honda's Racing Teams. Pretty much anything without a gasket except for the oil pan and water pump its just good insurance. And please do yourself a favor and don't buy the cheap autozone brand one.

2010年5月24日 · on the driver side it is the where the oil pump seats at and on the passenger side I believe it is where the main cap is. Basically next to bolts 18 and 16 and 15 and 17. You can see them on the oil pan mating surface. That's where the hondabond goes. Don't coat the whole thing with hondabond, only in those two spots! And try 2 torque passes.

2002年3月12日 · Been using both since and before this thread a decade ago.Hondabond was developed by Honda Racing.Is manufactured by Honda.According to look,smell and cure times,Hondabond and Utragray are 100% different.If you can't believe your smell & touch read the data sheets.They are similar only in that they are both gasket cements.

2003年2月17日 · Hondabond or Hondabond HT? Jump to Latest 1.9K views 1 reply 2 participants last post by 99_SH Feb 17, 2003

2015年3月26日 · The difference here is that Hondabond costs 4x as much and is harder to get a hold of. For my specific scenario, the casing has some gouging around the axle seal and around the input shaft seal. I am pretty sure the seals will work fine in both locations but I was planning to use a little bit of sealant on the sealing surfaces for insurance.

2007年10月25日 · I haven't found anything that works as good as Hondabond HT. I've used it for years without any problems. If you want to use a "regular" oil pan gasket, convert to a 4Gen oil pan and gasket. You can't use the 5Gen engine stiffener. You'll have to use the 4Gen stiffener and flywheel cover.

2007年10月18日 · OK, got everything on and back together. I put the hondabond on the four spots in the picture. No leaks so far. I was very careful tightening the nuts and bolts on the pan. I started by getting them all on hand tight, then a little tighter with just a socket wrench, then with my torque wrench I went 5 ft. lbs around, and lastly 9 ft. lbs.

2017年6月17日 · Then had pry it out from the pan with the smallest flat-head screw driver I had on hand & spend 2 hours scraping off their gasket material with a razor blade (4 needed) attached to a scraper. Brass wire brush was useless. One the engine block, it was easy to scrape off, since I was technically separating the HondaBond HT from the block.

2003年7月12日 · How long for Hondabond to dry enough to.. Jump to Latest 16K views 2 replies 2 participants last post by LT6916 Jul 12, 2003