2021年2月14日 · GNSS CTL STATE SUB-PAGE The GNSS CTL page shows the current status of the CRJ’s global navigation satellite system. The GNSS status page provides the following options: GNSS1 – Status // LSK 1R You can check the status of GNSS 1 by pressing LSK 1R, which opens the status page of GNSS1 GNSS2 – Status // LSK 2R

2017年4月23日 · The control display units (CDU) are the interface between pilots and the FMS units itself by means of data / information display and data entry. The FMS provides lateral guidance and vertical advisories based on the entered flight route, performance data and data collected from several sensors.

2017年8月1日 · The following chapter describes how to load the CRJ700 or CRJ900 in your flight simulator, which animations (like opening doors, cargo hatches) are available, a brief tour of the virtual cockpit with a short overview of available panels and pre-defined views, closing with the concept of operation (i.e. how do switches, pushbuttons, etc. work in ...

The FMS provides navigation and performance information for in flight use and pre-departure planning purposes. It is also used as a backup source for radio tuning. The Control Display Unit (CDU) and Flight Management Computer (FMC) make up the FMS.

This Quick Reference Handbook, (QRH), contains checklists and performance tables to be used with Aerosoft / Digital Aviation’s representation of the CRJ. This QRH is basically split up in 4 …

2012年9月28日 · There are two primary flight displays and 4 multifunction displays. The two multifunction displays in front of the pilot / co-pilot usually display navigation information from the CRJ700 avionics system. A Bombardier CRJ700 FMS unit, the Collins FMS-4200, is made part of the CRJ700 avionics system.

•Primary source of navigation used by the flight management system (FMS). •FMS interfaces between the GPS and aircraft navigation system to produce blended navigation inputs.

2021年4月8日 · First, ensure NAV SOURCE is set to NAV1/VOR1/LOC1 (green text). Not FMS1 (white) or FMS2/VOR2 (yellow). Second, on the FMC select Radio, then for NAV1 select MODE to MAN. This should circumvent the autotuning behaviour. Finally input your desired frequency in the entry field just above.

You are to set your destination and waypoints if you’d like then hit activate to make it active. When you arrive at your destination, close your flight plan so it resets

The following chapter describes how to load the CRJ in flight simulator, which animations (like opening doors, cargo hatches) are available, a brief tour of the virtual cockpit with a short overview of available panels and pre-defined views, closing with the concept of operation (i.e. how do switches, pushbuttons, etc. work in your flight sim).