2023年4月6日 · On a recent installation of a single phase 400 amp with standard ringless meter base going to two. 200A disconnects each going to 200 amp main lug panels. The state inspector filled it, because the phase were wired on opposite sides of the breaker on each disconnect. Exact memo on permit...

I plan on using a 400 amp meter base combo with a 200 amp QNR breaker for a 200 amp sub panel, a 100 amp QP breaker for a sub panel, a 70 amp QP breaker for a sub panel and a 20 amp AFCI/GFCI breaker for an outlet mounted on the meter rack. Are there any issues with this setup?

2022年1月12日 · Hello, As all main electric panels for 2 meter sockets (400 amp incoming 1 phase, 240 v to two 200 amp meter sockets for service two office suites) are back ordered since last year. We are stuck where we have the building and no meter panel to service the building. I was wondering if anyone know...

Customer: I need to replace a 200 amp meter base with a 400 amp base, splitting off 200 amps to my house and 200 amps to a new shop. I will need the local power company to upgrade the drop to 320 amps. My question is: what meter base will be appropriate for this change and are there any other issues I need to be concerned about to comply with codes? The existing lines enter the base from the ...

2023年4月16日 · The Meter Main will then supply the (2) 200 Amp Load Centers (one in the home utility room, and the second one mounted in the attached Garage, with a 60 or 100 Amp Breaker feeding the 100Amp Load Center in the RV garage.

2021年8月12日 · What size conductors should be installed on the line side of an all-in-one 320A/ 400A Meter Socket that feeds Two separate 200A Breakers. I do not have a load calc. One 200A will feed the residence and the other a "shop". We will often install 4/0Al for a residential 200A Service and call it good, with out a load calc.

2023年4月12日 · IN/KY area, 400 amp meter base and 2 gang 200 amp (2 - 100 amp sockets) meter base. No one around here has these. Any suggestions ?

2023年4月18日 · Meter base will likely be Eaton 324 N. Meter base is ~150 feet from the transformer. This would then feed two 200 amp panels (probably outside so I have the two service disconnects outside). POCO says we're responsible for the wire from the transformer to the meter base, that we connect it to the meter and they connect it to the transformer.

Customer: I require a PG&E approved 320/400 amp. 240 volt meter base with two seperate 200 amp. 2 pole breakers. I have tried Milbank and Square D and no one seems to be able to provide for a price under $1,200. East coast ringless meter …

2022年10月30日 · Finally got my 400 amp meter base (320 a) in. It had no lugs though, so including double and single lugs, the normally $250 base cost $600