Consideration should be given to flanking inlets on each side of the low point when the depressed area has no outlet except through the system. The purpose is to provide relief if the inlet at the …
Where significant ponding can occur such as in an underpass and in a sag-vertical curve, good engineering practice is to place flanking inlets on each side of the sag location inlet to relieve …
flanking inlets should be located on each side of the inlet at the low point. Flanking inlets are located and sized to capture the design flow and to act in relief of primary inlet at the low point …
flanking inlets should be used and the location checked to insure that the curb is not overtopped due to insufficient inlet capacity. • Inlets should be located so that concentrated flow and sheet …
Inlets at sag locations can easily become plugged with debris; therefore, it is good engineering practice to provide some type of relief. This relief can be accomplished by locating flanking …
Figure 22. Example use of depth at curb criteria to establish locations of flanking inlets. Figure 23. Median drop inlet. Figure 24. Embankment inlet and downdrain. Figure 25. Bridge inlet. Figure …
2016年9月13日 · A flanking inlet is recommended on each side of the inlet for a major sag point. At least one flanking inlet is required where the water can pond 2 feet deep or more. The …
This manual recommends flanking inlets be located so the depth of water at the flanking inlet ponds to half the allowable depth at the sag (or ½d B). With that said, flanking inlets are only …
An inlet is a common location for debris to collect and potentially clog a drainage system. From a hydraulic point of view, inlets should be large and widely separated. From a structural point of …
Flanking intakes function to: • Pick up silt before the velocity in the gutter becomes too slow. • Reduce ponding at the low point if volumes of water are high or if the intake at the low point …